To avoid having to pay for replacing your water heater in Desto, your best course of action is to take care of the water heater you have. Many homeowners forget about this simple part of household maintenance, probably because water heaters are so often out of sight that we take them for granted. For a simple start on water heater maintenance, try this three-step annual routine:
1. Lower the temperature on your water heater to somewhere between 115 and 120 degrees Fahrenheit. This is more than adequate for all household functions, and it will keep the water heater from overheating. Locate the knob on your unit (refer to the manual or manufacturer website if you have trouble) to dial it down. You’ll never notice the difference in temperature, but your water heater will have to work less and your energy bills will be lower.
2. Test the temperature and pressure valve by lifting the valve lever part of the way up, then allowing it to snap back into place. This should be followed by a gurgling sound as water is briefly released from the tank into the drain tube. If not, the valve may need to be replaced.
3. Flush the tank on a smaller scale. Rather than doing a full flush of the water heater, you can do a smaller one in much less time. To do this, just put a bucket under the drain valve and release the valve. When the bucket is full, close the valve back up and drain the bucket outside or into a sink. This will help get rid of sediment, but takes much less time than draining the whole tank.
It is also recommended that you get a plumber to inspect your water heater on a regular basis, according to the manufacturer’s recommendations. This three step plan is a good interim measure, however, and it only takes a few minutes each year.